So you find a piece of furniture with good “bones” and great detail, the perfect piece for painting. You choose a color and begin painting, but as the paint dries, you notice these awful spots bleeding through your paint…YIKES!!!
What do you do? Do you try another coat of paint, and another, and another, hoping it will cover?
Well, guess what? You cannot cover up “bleed through” with additional coats of paint. It will keep bleeding through, especially when using a paint that is porous, such as a clay, chalk and mineral paint, a chalk based paint, or milk paint.
You may think that using Kilz primer would do the trick, and it might, but a lot of times even that will not work. What looked like it had the potential to become a beautifully painted piece of furniture could possibly become something that you are ready to throw to the curb and give up. Read on to find out what I do to solve this problem.
The trick is to seal it off completely and then continue painting.
Okay, “So what is the best way to do that?”, you may be asking.
Let me share my experience with this happening to me and what has worked for me, so that you can end up with a beautifully painted piece that will end up looking like this…
My go to product in the past was to use Zinnser’s Bullseye Shellac, which works, but it took about 4 or 5 coats once, when I encountered a piece that had really bad red color bleeding through from the old finish underneath.
Here is what this piece of furniture looked like before I started…
This desk had been painted over the original stained finish, but as you can see, it was really rough and I thought the paint would go on smoother, if it were sanded smooth first. It did sand out smoother, but of course a lot of the original finish was exposed.
I knew this was a really old piece and when I saw the old finish beneath the paint glaring at me, I suspected that I would get some bleed through, and boy, did I!! It was a mess! So after that first coat of paint dried, I tried one of my products by American Paint Co. that I had been told would stop bleed through. It is their Clear Top Coat.
It took two coats, drying between each coat and the coats dried really quickly, in about 10 minutes. Placing blowing air on it will speed this process even more. Once the second coat had dried completely, I continued painting with 2 more coats of Navajo White. I then sanded the entire piece, prepping the surface for a smooth waxed finish, then wet distressed for a subtle aged appearance, and finished with a dark wax.
Inspiring Your Vintage Lifestyle,